English, Safety – Инструкция по эксплуатации Kenwood JK520

Страница 5

Advertising
background image

safety

Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.

Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.

If you do not need so much cord,
shorten it by wrapping any excess
cord around the bracket on the
underside of the powerbase

ቧ.

Always unplug your kettle

when not in use.

Never overfill - boiling water may
splash out.

Never put the kettle, powerbase,
cord or plug in liquid.

Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.

This kettle is not intended for use by
young children or infirm persons
without supervision.

Young children should be supervised
to ensure they do not play with the
appliance.

Caution: Do not operate the kettle
on an inclined surface.

Only use the powerbase supplied
and keep it clean and dry.

Make sure the lid is secure before
switching the kettle on.

Warning: Do not open the lid while
the water is boiling.

Take care when opening the lid -
droplets of hot water may be
ejected.

Make sure the kettle is switched off
before lifting or pouring.

Remove the kettle from the base
before filling or pouring.

Never put the kettle near or on
cooker hot plates or gas burners.

This kettle is for boiling water only.

This kettle is for domestic use only.

Failure to observe these cautions
may result in damage to the kettle.

before plugging in

Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.

This kettle complies with European
Economic Community Directive
89/336/EEC.

before using for the first time

Remove all packaging and any
labels.

Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.

key

ቢ flip top lid
ባ lid release button
ቤ water level windows
ብ on/off switch with neon
ቦ 360° powerbase
ቧ cord wrap
ቨ scale filter

to use your jug kettle

1 Fill it through the spout or lid. To

open the lid, press the lid release
button. The water level must be
between ‘MAX’ and 200mls (1 cup).

Be economical: do not boil more
water than you need.

To improve the quality of your drinks
always use fresh water.

Empty the kettle after each use.

2 Check the lid is closed.
3 Plug in and switch on. The neon will

come on.

4 Your kettle will boil and switch off

automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.

If you experience problems

with your kettle switching on

and off during use or

switching off before boiling,

check that the flat element is

free from scale - see

“descaling”.

Your kettle is fitted with a scale filter
to hold back limescale particles.

2

English

Advertising