Attaching the chest pad – Инструкция по эксплуатации Precor DISCOVERY SERIES_DPL0309
Страница 31
Seated Row Assembly Guide : Assembling the Equipment
13
Attaching the Chest Pad
To attach the chest pad:
1. Place the chest pad against the center upright assembly so that the screw
holes on the assembly line up with the outermost screw holes on the pad,
as shown in the following figure.
Figure 8: Chest pad attachment
Important: In the following step, be careful not to drop screws or washers into
the center upright. Inserting each screw into a socket wrench, then using the
wrench to position and tighten the screw, is recommended.
2. Place a 9mm flat washer over a ⁵₁₆-inch x 1¹₂-inch hex head screw, then
insert the screw through a screw hole in the center upright assembly and
into the corresponding hole in the pad. Partially tighten the screw. Repeat
this step to insert the other screw and washer.
3. Position the chest pad if necessary, then tighten both screws completely.
4. Press frame plugs into the screw hole openings on the center upright
assembly.