Bissell Паровая швабра с электрощеткой STEAM&SWEEP для уборки твердых поверхностей - Инструкция (Страница 8)

w w w. b i s s e l l . c o m
O
perations
1.
8
3. Replace the dirt container by
pushing it back into the swivel head
until it snaps back into place.
steam cleaning hard floors
Your steam&sweep is designed
to clean hard flooring such as
ceramic tile, vinyl, marble, stone
and sealed hard wood floors. use
of your steam&sweep on waxed
or some unwaxed floors may result
in a diminished glossiness. the
steam&sweep is not for use on
unsealed wood floors. ensure that
the steam&sweep is throughly test-
ed in an inconspicuous area prior to
cleaning a large floor area. also be
sure to check the care instructions
from your flooring manufacturer.
1. When the ready light illuminates,
begin cleaning by slowly passing
over the surface while pressing the
steam on demand trigger to emit
steam as needed.
2. To sanitize an area of your floor,
(attack invisible germs and bacteria)
leave the Steam&Sweep over the area
for a minimum of 15 seconds using
continuous steam, but no longer than
20 seconds. for larger areas, overlap
swivel head placement.
3. When the Steam&Sweep stops emit-
ting steam, turn the unit off. Simply
remove the water tank, refill, and
continue cleaning.
note: upon first use of this
steam product or first use of
a new filter, the pump may
make a "knocking" sound while
the filter fills with water. this
sound is normal and may last
up to one minute. continue to
depress the trigger until the
knocking sound subsides and
the unit emits steam.
WaRning:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
Tip:
The Steam&Sweep may be used
as both a steam mop and a
sweeper at the same time.
caution:
Exercise extreme care when
using the Steam&Sweep on
timber flooring. Ensure the
Steam&Sweep is thoroughly
tested in an inconspicuous
area prior to mopping a large
floor area. The Steam&Sweep
generates hot steam, so
when depressing the trigger
to apply steam, ensure the
Steam&Sweep is moving
continuously. The trigger does
not need to be depressed at all
times. Prolonged application
of steam in one area increases
the risk of damage to the
surface treatment on timber
floors. Check with your
timber floor treatment and
application specialist prior
to Steam&Sweep operation.
Regular foot traffic and direct
sunlight will wear down timber
floor surface treatment, making
it more susceptible to steam
damage. Exercise extreme care
when using the Steam&Sweep
on timber flooring.