Bissell Паровая швабра 2-в-1 со съемным ручным пароочистителем LIFT-Off STEAM MOP - Инструкция (Страница 8)

w w w. b i s s e l l . c o m
O
perations
8
Cleaning hard floors continued
1. When the ready light illuminates, begin
cleaning by slowly passing over surface
while pressing the steam on demand trigger
to emit steam as needed.
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) place the
center of the Lift-Off Steam Mop over the
spot for a minimum 15 seconds, but no
longer than 20 seconds. For larger areas,
overlap swivel head placement.
3. When the Lift-Off Steam Mop stops emitting
steam, simply remove the water tank, refill,
and continue cleaning.
NOTE: upon first use of this steam
product or first use of a new filter,
the pump may make a "knock-
ing" sound while the filter fills with
water. This sound is normal and
may last up to one minute. Continue
to depress the trigger until the
knocking sound subsides and the
unit emits steam.
Steam cleaning all living areas
Stubborn messes that resist traditional
water and cleaning solutions can be
removed with steam. Toothpaste or hair
spray on the bathroom sink, soap scum
on sliding shower walls—steam makes
all these far easier to clean.
1. Fill the water tank with cool tap water or
distilled/demineralized water and replace
back on Detachable Steam Pod.
2. Remove Steam Pod by pressing the pod
release button on the top of the carry handle
and pulling the pod out and away from the
lower base.
3. Remove cord from pod and connect the plug
to an appropriate outlet.
4. Remove hose from pod by pressing the clip
at the end of the hose where it connects to
the detachable pod.
5. Connect desired tool to the end of the hose.
6. When blue ready light turns on, the steamer
is ready to use.
7. To activate steam, press the pod release
button on the top of the carry handle. To stop
steaming, release the pod release button.
WARNING:
Never put descaling, aromatic
(not including the BISSELL Eucalyptus
Mint and water products), alcoholic
or detergent product into the steam
cleaner, as this may damage it or
make it unsafe for use.
Tip:
During first use, it may
take several seconds for
the Lift-Off Steam Mop
to begin steaming. The
water needs to flow
through the filter to the
heater. This delay will
only occur during initial
use or when using a
new filter.