Инструкция по эксплуатации ASSISTANT AH-1087

Am/fm alarm clock radio

Advertising

O W N E R ’ S M A N U A L

– 1 –

– 2 –

– 3 –

– 4 –

– 5 –

– 7 –

ENGLISH

– 6 –

ENGLISH

– 8 –

ENGLISH

AM/FM ALARM CLOCK

RADIO

Model AH-1087

LOCATION OF CONTROL

On/Off/Auto

Time

Set

Alarm

Set/Off

Sleep

Snooze

button

Hour

Minute

Volume Control / Buzzer

Band

Switch

Tuning

Control

AUTO

indicator

HI-LO

Dimmer

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.

CAUTION : THE CLOCK RADIO MUST NOT BE USED IN
ANY ENVIRONMENT WHERE IT MAY BE SUBJECT TO
THE DRIPPING OR SPLASHING OR WATER OR OTHER
LIQUIDS.

DO NOT CONNECT THE ANTENNA WIRE ON THE BACK OF THIS SET
TO ANY OUTDOOR ANTENNA

Mains plug is used as the disconnect device. It shall remain

readily operable and should not be obstructed during intended
used. To be completely disconnected the apparatus from supply
mains, the mains plug of the apparatus shall be disconnected
from the mains socket outlet completely.

BOTTOM OF SET : Battery compartment for 9 volt (6F22/6LR61)

battery (not included) for temporary time storage.

ELECTRONIC CLOCK OPERATION

1. Plug the AC line cord into 220V AC home outlet
2. The set is now working as an electronic clock and it will flash

the clock figures to show you it is not set correctly.

3. To set the correct time, depress the Time Set Button

and

Hour Button

simultaneously, release the buttons approxi-

mately before the correct time is reached. Now depress the
Minute Button

and the Time Set Button

simultaneously,

to set the readout to the correct time precisely.

RADIO OPERATION

1. Slide the ON/OFF/AUTO Switch

to “ON” position.

2. Slide Band Switch

to FM or AM position.

3. Turn the Volume Control

to desired volume.

4. Turn the Tuning Control

to select your favorite station.

5. Antenna

For AM reception, this radio incorporates a highly sensitive

ferrite core bar antenna.

For FM reception, this set is specially equipped with an external

wire as FM antenna. Be sure to untwist it to its fullest length for
peak performance.

WAKE TO RADIO

Having selected your station and set the volume at the desired

level, proceed as follows :
1. Slide the ON/OFF/AUTO Switch

to “AUTO” position.

2. Press the [ALARM SET] Button

and whilst this button is

depressed, press the Hour Button

and then the Minute But-

ton

until the time is reached at which you wish to wake. The

wake up time is now entered into the timer memory. To check
the wake up time, simply press the [ALARM SET] Button

and the clock will show the present time. The preset wake up
time will continue to be registered in the time memory and the
radio will switch on by itself at the same time the next day. To
switch the radio off, simply press the [ALARM OFF] Button

When wake to radio is set, but want to listen radio before alarm

time set. Press [SLEEP] button

once will turn radio on and

press [SNOOZE] button

once will turn radio off.

WAKE TO BUZZER

Set the controls as for “Wake to Radio” but volume control

to BUZZER position. The buzzer can then be switched off by
pressing the [ALARM OFF] Button

or it can be converted to

the radio by selecting switch

to “ON” position.

SLEEP TO RADIO

The radio can be set to play and to switch off automatically for

a length of time from 1 minute to 1 hour 59 minutes by following
this procedure – With all the controls preset in the “Wake to Radio”
positions, depress the [SLEEP] Button

and press the Minute

Button

to count down to the desired sleep time. To switch off

the radio before the end of the registered sleep time period, simply
press the Snooze Button

. Slide the ON/OFF/AUTO switch

to 'OFF' position if 'Wake to Radio' is not desire.

Press [SNOOZE] Button

once to elminate Sleep to Radio

memory effect when AC power is resume after temporaily suspen-
sion or unplug the unit.

SNOOZE CONTROL

The [SNOOZE] Button

allows the user an extra sleep time

of about 9 minutes after radio alarm is switched on at the preset
wake up time.

BATTERY BACK-UP

(For Temporary Time Storage Only)

Connect a 9 volt (6F22/6LR61) battery (not included) to the

terminals inside the battery compartment. In the event of a power
interruption, your set will not work normally from the mains supply

but there is now the advantage that your clock will continue to
work. The clock display will not light up, as the clock time will be
held in the memory. This also enables you to move the set from
place to place without re-setting the clock every time. The battery
back-up system is only meant to be used from short temporary
power interruption. For longer durations, the battery may become
exhausted or there may be some deviation in accuracy. When
the battery is exhausted, it should be removed from the set to
prevent leakage. If you do not wish to take advantage of the bat-
tery back-up system, your set will work normally without a battery.
However, if disconnected from the mains, the clock figures will
flash when the mains are re-connected and you must re-set the
clock as described in the Electronic Clock Operation paragraph.

GENERAL CARE

1. The cabinet can be cleaned with a slightly damp cloth (make

sure mains lead is disconnected from mains supply)

2. Avoid leaving the clock radio in direct sunlight or in hot,

humid, dusty places.

3. Keep the set away from heating appliances and appliances

that generate noise, such as fluorescent lamps, or motors.

4. Keep minimum 10 cm around the apparatus for sufficient

ventilation

5. The ventilation should not be impeded by covering the ventila-

tion openings with items, such as newspapers, table-cloths,
curtains, etc.

6. No

naked

flame sources, such as lighted candles, should be

placed on the apparatus.

7. Attention to be drawn to be environmental aspects of bat-

tery disposal.

8. The apparatus shall not be exposed to dripped or splashing

and that no objects filled with liquids, such as vases, shall be
placed on the apparatus.

9. Battery shall not be exposed to excessive heat such as

sunshine, fire or the like.

10. If the external flexible cable or cord of this item is damaged,

it shall be exclusively replaced by the manufacturer or his
service agent or a similar qualified person in order to avoid
a hazard.

11. For indoor use only.

SPECIFICATION

Power Source:

220V ~ 50Hz

DC battery :

9V (1 x 9V 6F22/6LR61 Not included)

Radio Frequency: AM

530-1600kHz

64-108MHz

Power Consumption: 5W

Warranty period

Гарантийный срок

Date of sale

Дата продажи

Model

Номер модели

Stamp

Печать магазина

Thank you for buying Assistant product. Read this manual

carefully to get the best performance form this unit.

Advertising