Indesit WITL 86 - Инструкция (Страница 7)

7
GB
Personalisations
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes
Maximum spin speed
Cottone 800 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol .
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.
 To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by
continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than
the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
C
Option
Effect Comments
Enabled with
programmes:
Delay Timer Delays the
start of the
wash by up to
24 hours.
Pess the button repeatedly until the LED corresponding to the
desired delay is turned on. The fifth time the button is pressed, the
function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay can
only be decreased if you wish to modify it.
All
Bleaching Bleaching cycle
designed to
remove the
toughest
stains.
Please remember to pour the bleach into extra compartment 4
(see page 8). This option is incompatible with the EASY IRON
option.
2, 3, 4, 5,
Rinse cycles.
Easy iron This option
reduces the
amount of
creasing on
fabrics, making
them easier to
iron.
If you set this option, programmes 4, 5,
7 and Delicate Rinse will be suspended, leaving the laundry to
soak (Anti-crease) and icon will flash:
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
This option is incompatible with the BLEACHING option.
3, 4, 5, 7, 8,
9, 10 and
Rinse cycles
Extra Rinse Increases the
efficiency of
the rinse.
Recommended when the appliance has a full load or with large
quantities of detergent.
1, 2, 3, 4, 5,
8, 9, 10, 12,
13 and Rinse
cycles.