Beko WMD 25080 R - Инструкция (Страница 7)

7
• This product is designed for home use.
• Your washing machine is adjusted to 230V.
• If the fuse in your house is less than 16A than have a
certified electrician deploy an 16A fuse.
• In case of transformer or non-transformer use, ground-
ing installation must be performed with a licensed
electrician. Any use before grounding is not our respon-
sibility.
• Never place your machine over a carpet covered floor.
Otherwise electrical parts of your machine may over-
heat. This may cause malfunction of your machine.
• Make sure hot and cold taps are connected correctly.
Otherwise your laundry may come out hot and torn .
• Please call certified service for a failure of electric plug /
cable.
• Be careful about your water hoses are not old. Do not
use old / torn water hoses. This may cause stain in your
laundry .
• At first use, washing must be performed at Cotton 90°C
program without loading with laundry for getting your
machine ready for washing.
• Performance of your washing machine depends on the
quality of water and hygiene compound used. If low
quality and unfitting cleaning material is used the stains
will be fixed. Before washing your laundry with stain
keep your attention on cleaning the laundry as explained
in following pages.
• This is period of keeping spare parts for your machine
to operate. Because of quality control procedures there
might be little amount of water in your machine. This
does not have any damage to your machine.
• Your machine is programmed for starting operation
again when electricity is off and on afterwards. You can
not press On / Off button to cancel program. Machine
will go on program when electricity is on. To CANCEL
the program press >Start/Pause/Cancel< button for
three seconds. (See. Cancelling a program)
If “Door” led on program progress display is blinking
program selection knob is middle position. In this case
turn the knob and adjust it again. If the warning contin-
ues call authorized service.
• After your machine starts operation, if Start/Pause/
Cancel key starts blinking than door is not locked. Open
and close the door again begin washing program again.
• If the “washing” led on the program progress display
is blinking either there is no water or tap is off. Check
2
Warning