Electrolux ENG2913AOW - Инструкция (Страница 15)

Problem Possible cause Solution
The temperature in
the appliance is too
low. The temperature regulator
is not set correctly. Set a higher temperature.
The temperature in
the appliance is too
high. Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed
correctly. Refer to "Closing the door".
Upper or lower
square is shown in
the temperature dis-
play. An error has occurred in
measuring the tempera-
ture Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
DEMO appears on
the Display. The appliance is in dem-
onstration mode (DEMO) Keep pressed approximate-
ly 10 sec. the Mode button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
6.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 15