Sony DCR-PC10E - Инструкция (Страница 99)

99
Additional information /
Дополнительная информация
Cause and/or corrective actions
• The tape is stuck to the drum.
m Eject the cassette. (p. 12)
• The tape has run out.
m Rewind the tape or use a new one. (p. 25)
• The POWER switch is set to VTR.
m Set it to CAMERA. (p. 13)
• The tab on the cassette is out (red).
m Use a new cassette or slide the tab. (p. 12)
• The lock knob is set to the left (lock) position.
m Set the knob to the right (unlock) position. (p. 14)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 8, 30)
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least 1
hour. (p. 93)
• Reset the date and time. (p. 85)
• You do not make a new recording after reinserting the cassette.
• The tape without cassette memory ejected after recording.
Cause and/or corrective actions
• The battery pack is not installed.
m Install the battery pack. (p. 11)
• The battery is dead.
m Use a charged battery pack. (p. 8)
• The AC power adaptor is not connected to mains.
m Connect the AC power adaptor to mains. (p. 30)
• While being operated in CAMERA mode, the camcorder has
been in Standby mode for more than 5 minutes.
m Set the POWER switch to OFF, then to CAMERA. (p. 13)
• The battery is dead.
m Use a charged battery pack. (p. 8)
• The ambient temperature is too low. (p. 87)
• The battery pack has not been charged fully.
m Charge the battery pack again. (p. 8)
• The battery pack is completely dead, and cannot be recharged.
m Use another battery pack. (p. 30)
• Only an NP-F100/NP-F200/NP-F300 battery pack can be used.
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.
Camcorder
Power
Symptom
The power is not on.
The power goes off.
The battery pack is quickly discharged.
The battery pack cannot be installed.
Operation
Symptom
START/STOP does not operate.
The POWER switch cannot be set to
PHOTO.
The cassette cannot be removed from
the holder.
{ and 6 indicators flash and no function
except for cassette ejection works.
“CLOCK SET” appears when the
camcorder is turned on.
The End Search function does not
activate.
Continued to the next page
English
Trouble check