Инструкция по эксплуатации Vitek VT-1208

Страница 7

Advertising
background image

НАПОЛНЕНИЕ УТЮГА ВОДОЙ

Убедитесь, что утюг отключен от сети.

1. Установите регулятор отпаривания (1) в положение “DRY”.

2. Медленно налейте воду в отверстие (9) до отметки “MAX”.

Примечание: Если вода очень жесткая, мы рекомендуем
использовать дистилированную или деминерализованную воду. Не
используйте другие жидкости.

УВЛАЖНЕНИЕ

При любой температуре глажения для смачивания ткани водой нужно
нажать кнопку разбрызгивания (3). Иногда необходимо нажать кнопку
несколько раз. При этом в емкости (13) должна находиться вода.

ГЛАЖЕНИЕ БЕЗ ПАРА

Включите сетевой шнур (5) в розетку.

Установите регулятор режимов отпаривания (1) в позицию “DRY”.

На терморегуляторе (8) выберите подходящую для изделия тем
пературу глаженья.

Когда лампочка индикатора (6) погаснет, можно начинать гладить.

ПАРОВОЕ ГЛАЖЕНИЕ

Включите сетевой шнур (5) в розетку.

Установите терморегулятор (8) в позицию «••» или «•••». Для
наилучшего результата не используйте для парового глажения
режим “”.

Подождите, пока лампочка индикатора (6) загорится и погаснет.

Выберите один из 6 режимов отпаривания, установив регулятор
режимов отпаривания (1) в нужную позицию “STEAM”.

РУССКИЙ

14

the soleplate. Therefore, ensure that the Steam Selector Knob is
always set to correspond with the salting on the Temperature Dial as
shown in the Table.

SURGE OF STEAM
The Surge of Steam provides an extra burst of steam, which is ideal
for removal of stubborn creases and wrinkles during Steam or DRY
ironing.

turn the temperature dial to the hottest selling within the Steam area

(•••or LINEN) and wait until the heating indicator light goes out.

Lift the iron slightly above the surface of the fabric, press the Surge

of Steam button down firmly and then release it during ironing. An
intense burst of steam penetrates deep into the fabric. For optimum
steam quality, leave an interval or at least four seconds between
pressing the Surge of Steam button.
NOTE: The Surge of Steam can be used when the Steam Selector is
in maximum setting. For a stronger surge of steam set the Steam
Selector on the "DRY" position.

VERTICAL IRONING
The Vertical Steam system allows you to use the Iron for vertical iron
ing. This is especially useful for getting wrinkles out of hanging
clothes, curtains, wall hangings, etc. Hold the iron vertically, in front
of the item to be steamed and press the Surge of Steam button.
WARHING: Never iron clothes on the body

SPRAYING
Spray may he used to dampen difficult fabrics, dry areas, wool items
and accidental creases. Press the spray button firmly to produce a
fine spray of water ahead of the iron, and continue ironing. Spray may
also be used with delicate (synthetic) fabrics, which are ironed at a
low temperature and thus cannot be steam ironed.

ENGLISH

7

1208.qxd 03.07.03 16:49 Page 14

Advertising