Sony XR-F5100EE - Инструкция

Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the leads under a screw, or caught
in moving parts (e.g. seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the power connecting lead 7 to the
unit and speakers before connecting it to the
auxiliary power connector.
• Run all earth leads to a common earth
point.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
Notes on the power supply lead (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
• The numbers in the list are keyed to those in
the instructions.
• The bracket 1 and the protection collar 4 are
attached to the unit before shipping. Before
mounting the unit, use the release keys 6 to
remove the bracket 1 and the protection collar
4
from the unit. For details, see “Removing
the protection collar and the bracket (4)” on
the reverse side of the sheet.
• Keep the release keys 6 for future use as
they are also necessary if you remove the
unit from your car.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
Note
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm.
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Connection example (2)
Notes (2-A)
• Be sure to connect the earth lead before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
Tip (2-B- )
For connecting two or more CD/MD changers, the
source selector XA-C30 (optional) is necessary.
Connection diagram (3)
A To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
B To the interface cable of a car telephone
Warning
If you have a power aerial without a relay box,
connecting this unit with the supplied power
connecting lead 7 may damage the aerial.
Notes on the control leads
• The power aerial control lead (blue) supplies +12 V
DC when you turn on the tuner .
• When your car has built-in FM/AM aerial in the
rear/side glass, connect the power aerial control
lead (blue) or the accessory power input lead (red)
to the power terminal of the existing aerial
booster. For details, consult your dealer.
• A power aerial without a relay box cannot be used
with this unit.
3-262-935-41 (1)
Installation/Connections
Установка/Подсоединение
FM/AM
Cassette Car
Stereo
XR-F5100EE
© 2004 Sony Corporation Printed in Thailand
1 2
Ч 4
3
7
4 6
8
1
5
Ч 2
Equipment used in illustrations (not supplied)
Аппаратура, фигурирующая в иллюстрациях (не прилагается)
Front speaker
Передний
громкоговоритель
Rear speaker
Задний
громкоговоритель
Power amplifier
Усилитель
BUS AUDIO IN
BUS CONTROL IN
2
1
Catch
Active subwoofer
Aктивный
низкочacтотный
гpомкоговоpитeль
Rotary commander RM-X4S
Повоpотный
диcтaнционный
пepeключaтeль RM-X4S
A
B
AUDIO OUT REAR
CD/MD changer
Проигрыватель CD/MD
BUS AUDIO IN
BUS CONTROL IN
Source selector*
Селектор источника*
* not supplied
не прилагается