Pioneer S-DJ08 - Инструкция (Страница 4)

En 4
Introduction
Main Features
This product allows you to use a single set of speakers for all your
music needs, from DJ performances to production, and ordinary
music enjoyment.
Audio response can be adjusted to perfectly match all situations,
from DJ performances to production and ordinary music
enjoyment.
Frequently used controls such as sound LEVEL, MUTE ON/OFF,
Power ON/Standby, EQ ON/OFF and source INPUT can be set
with the hand-held controller simultaneously for both right and
left speakers.
Confirm All Accessories
Installation
How to Install
Installation and Dimensions of Mounting Fixtures
Attaching the rubber feet
! Install at ear level.
! For natural stereo effect, the right and left speakers should be
installed in symmetrical and equidistant positions from the
listening position.
! Speakers should ideally be located at 30° angles from the
listening position (together forming a total 60° angle), and
rotated inward to face the listening position.
Note:
! To promote proper cooling, speakers should be separated 30
cm or more from walls. Locating the speakers too close to
walls could also cause a disruption of the speakers’ frequency
response.
Note:
! Never attempt to attach the rubber feet while holding the
speaker in a tilted attitude. Place a soft cloth or blanket on the
floor, and lay the speaker on its side when attaching the feet.
A speaker’s playback sound is delicately influenced by
conditions in the listening room. To produce optimum listening
conditions, take due consideration of the conditions of your
installation location before beginning actual installation.
CAUTION
! To promote proper cooling, please assure that sufficient space
is preserved between the speakers and nearby walls or other
components (minimum 30 cm or more above, behind, and
to right and left sides of each speaker). Leaving insufficient
space between the speaker and walls or other components may
lead to rising interior temperatures, leading to malfunction or
damage.
! Power cords (2)
! Link cable (1)
! Controller (1)
! Rubber feet (8)
! Warranty
! Operating Instructions (this document)
! As shown in the accompanying illustration, two screw
holes are provided on the bottom of each speaker to allow
attachment to speaker mounting fixtures. When using such a
mounting fixture, consult the usage instructions provided with
the fixture and be sure it is capable of supporting the weight
of the speaker. An improperly supported speaker could fall,
causing serious damage or personal injury.
! Pioneer accepts no responsibility for any damages or other
issues arising from the use of speaker mounting fixtures,
including mistaken or insufficient assembly, improper
installation, insufficient ability to support speaker weight,
misuse, modification, or accidents.
Note:
! Over tightening of screws could cause stripping of threads
and damage to the product. Take proper precautions when
tightening.
The provided rubber feet may be used in accordance with the
needs of the installation. Attach one rubber foot to each corner of
the bottom of the speaker. Note that insufficient slip-resistance
may be provided by the rubber feet in some locations, so they
should not be used on slippery surfaces.
60 mm (S-DJ05)
150 mm (S-DJ08)
* Illustration depicts
the S-DJ08 model.
* Illustration depicts
the S-DJ08 model.
! These speakers are provided with no accessory speaker stands,
mounting fixtures, or screws. If such facilities are desired,
please provide your own as required.
M5 tapping screw, depth 13 mm (S-DJ05)
M8 tapping screw, depth 13 mm (S-DJ08)
Rubber feet