Philips FC6842 Triathlon - Инструкция (Страница 12)

◗ With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum clean
small hard floor areas.Turn the tube 90 degrees anticlockwise until the nozzle is positioned
lengthwise with the brush strip still folded out of the nozzle housing (fig. 37).
◗ With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean
large soft floor areas.Turn the tube 90 degrees anticlockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the nozzle housing (fig. 38).
◗ With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean
small soft floor areas.Turn the tube 90 degrees anticlockwise again until the nozzle is
positioned lengthwise with the brush strip still folded in (fig. 39).
Crevice nozzle
Use the crevice nozzle to clean narrow corners and hard-to-reach places.
Small nozzle
The small nozzle is especially suitable for vacuuming stairs, upholstery, curtains, etc.
B If necessary, remove fluff from the nozzle with your hand and then vacuum it.
Shampooing floors
1 Start shampooing as far away from the door as possible and then work your way towards the
door.
2 Apply shampoo by squeezing the trigger on the handgrip of the tube (fig. 40).
3 Make overlapping strokes to cover the entire area to be cleaned.
B If there are still traces of liquid on the area you have just cleaned, pass the vacuum cleaner over
this area once more without applying shampoo.
4 After shampooing, release the trigger and switch the pump off. Keep the motor running (fig. 41).
5 Lift the nozzle off the floor and simply let the appliance suck up dry air for some time to dry
the inside of the suction hose and tubes (fig. 42).
6 Switch the appliance off.
Carpet shampooing: three techniques
Depending on the degree of soiling, you can use (and combine!) the following three carpet
shampooing techniques.
◗ Freshening up
If the carpet (or part of it) merely requires freshening up, you do not need to apply a lot of
shampoo.
It is probably sufficient if you only apply shampoo when making the first stroke towards you.
Then release the trigger and move the nozzle over the cleaned area a few times without applying
shampoo.
◗ Deep cleaning
For thorough cleaning of (part of) a very dirty carpet, move the nozzle over the area to be
cleanded a few times while applying shampoo.
◗ Extra thorough cleaning (fig. 43).
For extra thorough cleaning (badly soiled areas, stubborn stains), switch the motor off but keep the
pump running.
Squeeze the trigger to apply shampoo.
Allow the shampoo to act on the area for several minutes.
Be careful not to apply too much shampoo, as this may damage the carpet.
ENGLISH 12