Confirming the remaining tape time, Preventing accidental erasure of recordings – Инструкция по эксплуатации Panasonic NV-VX37EN
Страница 41
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
^ mm - ^7it№
“ (->44)
• mmmmmrn -
° K^nmm
i$i^ -
°
°)
♦
■ tmmmmmkO -
Confirming the Remaining Tape Time
During recording and playback, the Remaining Tape Time
Indication O automatically displayed, so you always
know how much time you have left on the cassette.
However, to ensure correct display of the remaining tape
time, the tape length of the cassette being used must be
set correctly on the Movie Camera. (-♦ 44)
•When recording or playback starts, the Tape Length
Indication disappears, and in its place the [R] Indication
O flashes while the remaining tape time is being
calculated. A few seconds later, the Remaining Tape
Time Indication appears. {[R] means Remaining.)
•When the remaining tape time is less than 2 minutes,
the [R] Indication and the Remaining Tape Time
Indication start to flash.
When you use a cassette bearing the [P] mark Q or
other special types of cassettes, the Tape Counter
Indication may not be very precise.
■ Preventing Accidental Erasure of
Recordings
• Recording on a previously recorded cassette erases the
existing scenes and sound.
•To protect important recordings against accidental
erasure, use a screwdriver to break off the tab © on
the cassette {some cassettes have sliding-type tabs).
•To be able to record again on a protected cassette,
firmly cover the hole where the tab was with two layers
of adhesive tape ©.
46