Measurement and marking, Cutting a hole for your cat flap, En ru no da sv fi – Инструкция по эксплуатации Petsafe Manual 4 Way Locking Classic Cat Flap

Страница 39: Tools required, A) in wood and pvc/upvc/metal

Advertising
background image

39

EN

RU

NO

DA

SV

FI

Replacement flaps available online

Before installing your cat flap

please read the following step-by-

step instructions carefully.

Tools required

• Pencil

• Ruler

• Jig or Keyhole Saw

• Drill

• 5 mm (

3

/

16

”) drill bit

• Screwdriver

• Tape measure

• Sand paper

Measurement and marking

Measure the belly height of your cat. This is usually 100 mm to150 mm (

Fig. 1).

Mark this measurement on the outside of your door and draw a straight

horizontal line 169 mm (

Fig. 2).

Please bear in mind that this line will eventually be the bottom of the

hole you will cut in your door and that the frame of the cat flap will be

slightly lower. If necessary, this line may have to be raised slightly to

account for this.

FIG.1 FIG.2

Cutting a hole for your cat flap

a) In Wood and PVC/uPVC/Metal

The cat flap requires a square cut-out of

169 mm x 169 mm (

Fig. 3).

Not to scale - for best results you should
refer to the enclosed cutting template.

(x)

(x)

169 mm

FIG.3

169 mm

Wooden doors

PVC/uPVC/Metal

Advertising