Aaaintenance and cleaning, Water in let filters, Pump filter – Инструкция по эксплуатации Whirlpool AWG 328
Страница 29
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
AAAINTENANCE AND CLEANING
• Unplug your machine.
• Close the water tap.
Water in let filters
On the tap part of your machine's water inlet hose and at the extremities of the
water inlet valves, there are filters to prevent entrance of dirt and foreign bodies
into the water to the machine. If the machine is unable to receive sufficient
water although your water tap is opened, these filters should be cleaned.
• Remove the water inlet hose.
• Remove the filters found on the water inlet valves by using tweezers or pliers
and wash thoroughly with a brush.
• Clean the filters of the water inlet hoses located on the tap side by removing
manually, together with the seal.
•
After cleaning the filters, they can be refitted by reversing the removal
procedure.
Pump filter
The pump filter system prolongs the life of your pump, which is used to drain the
dirty water. It prevents lint from entering the pump. Cleaning your pump filter
every 2-3 months is recommended. To clean your pump filter:
• Remove the kickplate by pushing upwards with your hand from the lower claws
and pulling towards yourself.
•
Before opening the filter cover, place a cup in front of the filter cover to
prevent flow of the remaining water in the machine.
• Loosen the filter cover by turning counter clockwise and drain the water.
• Remove the foreign bodies from the filter.
• Check for the rotation of the pump manually.
• Afteryou have cleaned the pump, refit the filter cover by rotating clockwise.
• Refit the kickplate by holding from the claws and pushing it.
•
Do not forget that if the filter cover is not properly refitted, it will leak
water.
27