Sharp SJXE35PMSL - Инструкция (Страница 12)

12
3
Remove the 2 screws of the lower part of the cabinet
and use these screws to set the foot cover. (At first, the
foot cover is inside the refrigerator compartment.)
NOTE
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not place
next to heat generating appliance.
• Do not place your refrigerator directly on the ground. Provide
suitable stand.
• To insert the power plug when the door is opened, door alarm
sounds but it is not abnormal. This sound stops when closing
the door.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
INSTALLATION
WARNING
■ Do not install the refrigerator in a damp or wet
location. It may cause the damage to the insulation
and a leak. Dew may also appear on the outer cabinet
and it causes rust.
■ Connect the earth pin to the earth terminal properly.
When transporting
• The casters allow the refrigerator to move back and forth.
• Carry the refrigerator by holding the handles located on the
rear and the bottom.
• Wipe up water in the evaporating pan. Before wiping up
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
rear bottom
Free standing type
2
Use the two front Adjustable feet to place the refrigerator
flatly and firmly on the floor.
Foot cover
Screw (2 screws)
Adjustable foot
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
• By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
• If using the refrigerator in the smaller space dimension
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
• The space between the rear of the refrigerator and the
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts which
are extremely hot during the operation.
60mm
or more
60mm
or more
90mm
or more
1330 mm
1160 mm
Overall space required in use
Evaporating pan
Casters
SJ-XE35PM:2pcs.
SJ-XP39PG, SJ-XE39PM:
4pcs.
(B803).indb 12 2017/02/17 14:53:30