Yamaha RX-V665 - Инструкция (Страница 62)

60
En
Troubleshooting
AM
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is weak or the antenna
connections are loose.
Adjust the AM loop antenna orientation. 18
Use the manual tuning method. 29
There are continuous
crackling and hissing
noises.
Supplied AM loop antenna is not
connected.
Connect the AM loop antenna correctly even
if you use an outdoor antenna.
18
The noises may be caused by lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
It is difficult to completely eliminate noise,
but it can be reduced by installing and
properly grounding an outdoor AM antenna.
18
There are buzzing and
whining noises.
A TV set is being used nearby. Move this unit away from the TV set. —
Remote control
Problem Cause Remedy
See
page
The remote control
does not work or
function properly.
Wrong distance or angle. The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees
offaxis from the front panel.
9
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, strobe
light, etc.) is striking the remote control
sensor of this unit.
Adjust the lighting angle or reposition this unit. —
The batteries are weak. Replace all batteries. 9
The remote control ID of the remote
control and this unit do not match.
Match the remote control ID of this unit and the
remote control.
55
The remote control code is not correctly
set.
Set the remote control code correctly using “List of
remote control codes” at the end of this manual.
52
Try setting another code of the same manufacturer
using “List of remote control codes” at the end of this
manual.
52
If this unit does not work when you press oCursor,
do the following.
When the key does not work during DVD disc menu
operation: press the hInput selection keys on
the remote control again.
When the key does not work during OPTION menu/
Setup menu operation: press the key applicable for
the current menu operation again.
—
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Problem Cause Remedy
See
page