Yamaha DVD-S663 - Инструкция (Страница 27)

23
En
Playback Operation
Eng
lish
■ To select a subtitle language
During playback, press SUBTITLE to
switch or turn on/off the subtitle language
recorded on the contents.
y
• For information about external subtitle files, see
“Selecting DivX ® external subtitle group (except
Korea model)” on page 38.
• For external subtitle files, the following subtitle
format filename extensions are supported (note
that these files are not shown within the disc
menu): .srt, .sub, .ssa, .smi
• The filename of the movie file has to be repeated
at the beginning of the filename for the external
subtitle file.
• For Korean model, Korean and English external
subtitle files are available.
• Some external subtitle files may be displayed
incorrectly or not at all.
• Some discs cannot be played depending on disc
characteristics or recording conditions.
• The number of external subtitle files that can be
switched for the same movie file is limited to a
maximum of ten.
You can play back MP3, WMA, WMV, JPEG,
and DivX
® files saved on your supported USB
device.
Supported USB devices
This unit supports USB mass storage class
devices using FAT16 or FAT32 format. The
supported devices are flash memories, card
readers, and portable audio players.
• Some devices may not work properly.
• If “Device not supported” appears on the TV
screen when you connect the USB device, follow
the procedure below.
– Set this unit to the standby mode, and then turn
it on again.
– Disconnect the device when this unit is in the
standby mode, then connect it again and turn
on this unit.
– Connect the AC adapter if the adapter is
supplied with the device.
If “Device not supported” appears even after you
perform this procedure, the device is not usable
with this unit.
• If “USB current protection active. Device not
supported” appears on the TV screen, the device
is not usable with this unit because the power
consumption of the device is too high.
• This unit cannot read more than two card reader
slots at once, though it can recognize up to six
slots. The first slot has priority.
• Do not connect devices other than USB mass
storage class devices: USB chargers, USB hubs,
PCs, etc.
• This unit is not compatible with HDDs.
Playing data files
1 Connect your USB device to the USB port
of this unit (see “USB port” on page 12).
➜ “Press USB key to switch device”
appears on the TV screen.
2 Press USB .
• The reading time may exceed 30 seconds
due to the number of files/folders.
➜ The file menu appears on the TV screen.
3 Follow the procedure in “Playing data discs
(MP3/WMA/WMV/JPEG/DivX
® )” on
page 21.
Notes
Using a USB device
Notes