Yamaha DVD-S663 - Инструкция (Страница 46)

42
En
Troubleshooting
Refer to the chart below when this unit does not function properly. If the problem you are
experiencing is not listed below or if the instruction below does not help, set this unit to the
standby mode, disconnect the power cable, and contact the nearest authorized Yamaha
dealer or service center.
Problem Solution
No power Connect the AC power cable properly.
Press STANDBY/ON on the front panel to turn on the power.
This unit cannot read CD or
DVD Use a commonly available CD/DVD lens cleaner to clean the lens
before sending this unit for repair.
“NO DISC” appears in the front
panel display Check that the disc is placed in the disc tray correctly.
“UN DISC” appears in the front
panel display The disc being loaded is not supported by this unit. Check the disc type
(see “Playable disc formats” on page 4).
Disc or file does not play The CD-R/RW, DVD+R/RW/R DL, and DVD-R/RW/R DL must be
finalized.
Check that the disc label is facing up.
Check whether the disc is defective by trying another disc.
If you have recorded a JPEG, MP3, or WMA disc yourself, check that
your disc contains at least ten JPEG picture files or five MP3/WMA
music tracks.
Check the region code (see “Region codes” on page 3).
For MP3/WMA, check that the sampling rate and bit rate are
compatible.
For JPEG, check that the resolution is compatible (see “Specifications”
on page 48).
For WMA/WMV, check that the file is not protected by DRM (Digital
Rights Management).
For WMV, check that the file has been encoded by WMV9.
For WMV, check that the file is not Advanced Profile.
For WMV, check that the resolution of the file is 720 x 480/720 x 576
pixels or less.
No picture Refer to the manual supplied with your TV to select the video input
channel correctly. Change the TV channel until you see the DVD
screen.
Turn on your TV.
Check the video connection.
No picture is displayed when
you make HDMI connections
(using the HDMI jacks) Follow the steps below to change the [HDMI VIDEO] to [AUTO].
1.
Press OPEN/CLOSE ( ) on the front panel or press and hold
7
on the remote control to open the disc tray.
2. Press 2 on the remote control.
3. Press SUBTITLE on the remote control.
Troubleshooting