Additional information, Troubleshooting, Power – Инструкция по эксплуатации Yamaha BD-S1067

Страница 82: Basic operation, Disc playback, Power basic operation disc playback, Power ■ basic operation ■ disc playback

Advertising
background image

37

En

ADDITION

AL IN

FORMATION

5

Eng

lish

ADDITIONAL INFORMATION

Refer to the table below when this Player does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, turn off this Player, disconnect the power cable, and contact the nearest
authorized Yamaha dealer or service center.

Power

Basic operation

Disc playback

TROUBLESHOOTING

Problem

Possible causes and solutions

No power.

– Connect the AC power cable properly.
– Press (p) on the front panel to turn on the power.

The Player power is turned off.

– The power will be automatically turned off after 10 continuous minutes of inactivity (no

playback).

Problem

Possible causes and solutions

The remote control does not work.

– Use the remote control within its operating range. (p. 5)
– Replace the batteries. (p. 5)
– Check the ID settings for the main unit and the remote control. (p. 9)

Buttons do not work.

– Press and hold p on the front panel for around 5 seconds to restart this Player.
– To completely reset this Player, unplug the power cable from the AC outlet for 5 - 10

seconds, plug the power cable to the AC outlet again, and then turn on this Player.

Password is forgotten.

– Press and hold

and

on the front panel simultaneously when no disc is inserted

and playback is stooped to set the Player to default setting (Security setting (p. 30) is
also reset).

Problem

Possible causes and solutions

The Player cannot play a disc.

– Take out the disc and clean it. (p. 4)
– Make sure that the disc is loaded properly (aligned in disc tray and label-side up). (p. 4)
– Use a disc supported by the Player. (p. 3)
– Remove the disc and then check whether the Player supports the disc or not. (p. 3)
– Check the region code. (p. 3)
– Check whether the disc is defective by trying another disc.
– The CD-R/RW, DVD+R/RW/R DL, and DVD-R/RW/R DL must be finalized. (p. 3)

Video stops.

– The Player will stop if it senses shock or vibration.

The Player makes a snapping sound
when starting playback or loading a
disc.

– These sounds are not malfunctions of the Player but are normal operating conditions.

Advertising