Samsung HT-C5550 - Инструкция (Страница 19)

English
19
02
Connections
Installing the Speakers on the Tallboy Stand
* HT-C5550 only - Front/Surround speakers
Turn the Stand Base upside-down and
connect it to the Stand.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be
careful not to put excessive force.
Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For
connecting Speaker & Stand) clockwise into
the hole on the rear of the speaker using a
screwdriver.
This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the
red terminal (+), and then release the tab.
Connect the connecting plugs to the back of the product by matching
the colours of the speaker plugs to the speaker jacks.
1.
2.
3.
Black Red
FM ANT
SPEAKER IMPEDANCE : 3
FM ANT
SPEAKER IMPEDANCE : 3
SPEAKER IMPEDANCE : 3
Front Speaker (R)
Subwoofer
Surround Speaker (R) Surround Speaker (L)
Front Speaker (L)
Centre Speaker
In case of HT-C5500
* Refer to page 18 for the speakers of HT-C5550.
4
2
Stand
Stand
Base
1
3
Stand
Speaker
5
HT-C5500_CIS_ENG_0916.indd 19 HT-C5500_CIS_ENG_0916.indd 19 2010-09-16 3:35:43 2010-09-16 3:35:43