Beko CS 58000 - Инструкция (Страница 37)

Part Important Installation and preparation of your oven
Before your opplionce is connected to the
mains electricity supply check to ensure that
the voltage and the frequency shown in the
data plate corresponds with your power supply.
The data plate is situated back cover of the
oven, or it is situated in the front of the storage
compartment and can be seen by opening the
storage compartment cover or pulling the drawer.
Warning!
This appliance must be earthed
Our company shall not held responsible for any
damage caused by the utilisation of the oven
without ground socket.
Before applying to Authorized service, have
the electrical wiring of your home ready for
connection.
If the appliances is connected by a plug, that
the plug is easily accessible after installation
(but not above the hob)
^^This product must only be installed by a
qualified electrician eg. local electricity company
to a suitable double pole control unit with a
minimum contact clearance of 3 mm in all poles
which should be adjacent to (but not above)
the cooker in accordance with lEE regulation.
Failure to observe this instruction may result in
operational problems and invalidation of the
product warranty. If the appliance is connected
by a plug, that the plug is easily accessible
after installation (but not above the hob).
The cable length should be 2 mt max hr isolation
safety.
In models writh "small type- terminal block'"
In mix models a cable supplied with a plug with
your oven (H05 V V-F 3G 1.5 mm2)
^ if a coble without a plug is provided together
with your oven (H05 V V-F 3G 2,5 mm2 )
Take care to connect as below:
Brown coble = L (Live)
Blue coble = N (Neutral)
Green/Yellow cable = E (Earth)
If your oven is supplied without supply cord use
schemo-l to choose supply cord and use sc he mo­
ll for installation of cord.
The cable length should be max 2m long for
isolation safety.
^Open the terminal block cover.
^Connect the supply coble according to wiring diagram on the rear
cover.
Fix the supply coble to main body with integrated screw via cable
tightener.
^ Assembly the terminal block cover to its place.
Your oven is suitable for single and three phase connection.
^The mains coble must pass through the coble clomp.
^The mains cable should be routed away from the appliance and ...
particular ventilation slots, the vent outlet and should not be obstructed when
Ш
© о
Connection Type Monophase Three phase
with Neutral
Two phase
with Neutral
Voltage 220/230/
240 V
380/400/
415 V
380/400/
415 V
Supply cord type
(max 2m long)
3x2,5 mm2
H05 V V-F
5x2,5 mm2
H05 V V-F
4x2,5 mm2
H05 V V-F
Q
I