Инструкция по эксплуатации Beko CS 58000
Страница 63
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Oven inferior
Before switching on again ensure that all controls are in the
OFF position. Take out all trays and the grill out of the oven.
Clean out the interior with a piece of moist, soapy cloth.
Then, clean it once more with a wet piece of cloth and let
it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may be
used after carefully reading the warning that are written on
the labels.
Warning!
Never clean the inside of the oven and trays with hard
brushes, steel pads or knives.
Special cleaners that are commercially avaible may be used
after carefully reading the warning that are written on the
labels.
Catalytic-enamelled models;
The oven interior of this
model is coated with catalytic enamel since the catalytic
enamel cleans itsellf, you do not have to perform an extra
cleaning after the cooking operation.
If your oven obtains steel rack;
To
clean the steel rack, unscrew the
4 screws. After cleaning operation,
assemble the steel rack to the oven
body again.
Confroi panei
Wipe over the control panel with a damp cloth and polish
with a dry cloth. Do not use oven cleaners or aerosols,
scouring pads or abrasive powder for cleaning
the plastic knobs as damage will occur.
Do not attempt to remove any of the
control knobs from the panel as this
may cause damage and is a safety
hazard.
Oven door
Wipe over the door outer panel with
a cloth wrung out in hot soapy water,
then after wiping with a
cloth wrung out in clear water. Do not
use scouring pods or abrasive powder
which may scratch the surface. Take
care during cleaning not to damage
or distort the door seal.
Removing the interior giass
of the oven door
When you wish to clean the interior
glass of the oven door, use a
screwdriver to remove the top and
bottom washers that connect the
interior gloss to the door, take the
glass out, and clean and rinse it off
using a piece of cloth moistened with
soapy water. After drying, position
the gasket back into its place and fit
the glass onto the door.
Repiaring the oven iamp:
1. Unplug the power cable.
2. Then, remove theprotective glass cover of the lamp inside your oven
by turning it counterclockwise.
3. Then, remove the bulb by turning it counterclockwise.
4
. After installing the correct bulb obtained
from an Authorized Service, reinstall the
protective glass of the lamp.
29