Beko CS 58000 - Инструкция (Страница 41)

Part 4* Operating the top burners
4m I Operating the gas burners
To obtain maximum
efficiency
A correct use to burner
results in gas saving and
better out put. Therefore
we recommend to use
saucepans whose base
completely cover the
flames. Four saucepans
with much smaller
diameters to be put
auxiliary burner, use the
pan support adaptor.
If your cooker has flame
failure device on gas burners;
In cose of any flame failures with any
reasons in the top burners, the flame
failure device immediately cuts of the
gas flow. It is also a safety device for
the wrong use of the children.
You should turn the knob to the counter-clockwise
direction by pressing. You should ignite by pressing
the knob and wait for its ignition. You should keep the
knob at pressed position for 3-5 seconds after you see
the flame around the burner. Repeat the sequence of
operations if the flame does not continues.
Use of top gas burners
Turn the relevant knob by slightly
pressing in counter clockwise direction.
The large flame on the knob corresponds
to maximum capacity position and the
small flame corresponds to minimum
capacity position.
Ignition by button
In models with ignition;
It provides automatic ignition.
When the button is pressed and released all
plugs spark at the same time. The ignition starts
at the burner through which the gas flows. If
an ignition does not occur, repeat the same
action. Holding the button at pressed position
does not provide ignition.
Ignition from the knob
In models with ignition;
You should turn the knob to counter­
clockwise direction by pressing. The spark
occurs itself immediately on the burners till
you take your hand off the knobs.
After you release the knob, if the ignition
does not continue repeat the same process
by keeping the knob pressed for 15 seconds.
If still no igniton occurs, wait for 1 minute
and repeat again.
Warning : Do not keep the knob in pressed
position more than 15 seconds.